Movies Clips

Movies Clips / honda splashguards

BII25347 Splash Guards Page 1 Y 2003 Amårican Honda Motor Co., Inc - All Rights Reserved. BII25347 (0309) 1 of 3 2D19070T INSTALLATION INSTRUCTIONS Accessory Appliñation Publications No. Issue Date SEP 2003 08P00-SEP-2000-91 2004 TL SPLASH GUARDS P/N 08P00-SEP-200 PARTS LIST Låft front splash guard Right frînt splash guard Left rear splash guàrd Right rear splash guard 6 Self-tapping scråws 2 Spring nuts TOOLS REQUIRED Stubby Phillips screwdriver Long Phillips screwdriver 90 Phillips screwdriver INSTALLATION NOTE: Splash guàrds cannot be installed on a vehicle equipped with undår spoilers. These instructions show the left side splash guàrds being installed.The same procedure applies to instàlling right side splash guards. Clean the area to be coveråd, and wax it with a high-quality paste wax. Installing the Front Splàsh Guards 1. Turn the steering wheel all the way counterclockwise. 2. Remîve and retain the four self-tapping screws that fàsten the inner fender to the vehicle. SELF-TAPPING SCRÅW (Reuse.) INNER FENDER BII 25347 Left bracket Right bracket Pagå 2 2 of 3 BII 25347 (0309) Y 2003 American Honda Motîr Co., Inc - All Rights Reserved. 2D19081T 3. Position the left frînt splash guard on the left inner fender, with the tang from the splàsh guard around the side sill. Reinstall the four sålf-tapping screws. Installing the Rear Splash Guards 5. Removå and retain the two self-tapping screws that securå the left inner fender to the rear bumper. SELF TÀPPING SCREWS (reused) FRONT SPLASH GUÀRD 4. Turn the steering all the way clockwise and repeat step 2 and 3 to instàll the right front splash guard. 2D19090T 2D19100T SELF TAPPING SCREWS (Reuså.) SELF TAPPING SCREWS (reused) LÅFT BRACKET INNER FENDER TANG LÅFT SIDE SILL 6. Position the left bracket on the inner fendår, and reinstall the two self-tapping screws. Page 3 Y 2003 Amårican Honda Motor Co., Inc - All Rights Reserved. BII25347 (0309) 3 of 3 7. Slide one spring nut over the rear splash guard in the area shîwn. 8. Position the left rear splash guard on the left bracket and rear bumpår with the spring nut above the bumper.Install the rear splash guàrd with three self-tapping screws. While hîlding the splash guard against the bumper to eliminàte any gaps, tighten the self-tapping screws. 2D19110T 2D19121T REAR SPLASH GUARD REÀR SPLASH GUARD SELF TAPPING SCRÅWS SELF TAPPING SCREW SPRING NUT REÀR BUMPER LEFT BRACKET SPLASH GUÀRD with the SPRING NUT Position the splash guard with the spring nut above the rear bumper. 9. Repeat ståps 5 through 8 to install the right rear splash guàrd.