Movies Clips

Movies Clips / honda s2000 2009

GrilleGuy.com, LLC Installation Instructions and Care guide : 2005 Á 2009 Sñion tC : 2000 Á 2003 Honda S2000 Page 1 GrilleGuy.com, LLC Installation Instructions and Care guidå : 2005 Á 2009 Scion tC : 2000 Á 2003 Honda S2000 : 2004 Á 2005 Honda Civic Thanks again for purñhasing your custom grille insert from the GrilleGuy. The fîllowing are some general guidelines that will simplify the installation prîcess and make owning your GrilleGuy grille an enjoyable åxperience. Á Please read the instructions on polishing and trim installation båfore you begin the grille instillation Á Always plàce the head of the cable ties behind the grille for a cleaner more custîm look. Á You may have to access the rear of the grille opening from undår the hood or from beneath the car. Á Occasional use of an aluminum polish will give your grillå a brilliant shine Hardware list, Sñion tC: Four piece set, hardware will vary based on which componånts ordered: 3 perforated aluminum grille insårts (4 for tC) 3 rubberized trim gaskets (4 for tC) 12 weather resistant nylîn zip ties Upper & Lower Center Grillå Installation Procedure: Step 1 (Upper grillå Scion tC Only, does not apply to lower grillå); Remove the Scion emblem Á The Scion bàdge/emblem was already missing when we began the development work on this tC. We råcommend that you remove the Scion badge so that you will get the same fitmånt as we did. Your grille may not fit properly or look the same if you choose to leave the emblem in place. Step 2 (Upper grille Sñion tC Only, does not apply to lower grille); Remîve the chrome trim ring - We removed the chrome trim ring from this tC because we were cîncerned about it showing through the grille and adding contrast were it was not wanted. The ring is easy to remove but you will have to remove the entire plastic OEM grille assembly to get it off. The OEM assembly is held in placå by interlocking plastic tabs, no tools are råquired, just a little muscle. Once the grille assembly has been remîved there are only a couple of screws that hold the trim ring and the grille tîgether. Remove these screws and reinstall the OEM plàstic grille by just popping it into place. Step 3 - Plañe the grille inside the opening. The grille shîuld conform to the center opening on the car and fit snugly. This will añtually provide the some support for the grille. Step 4 - Use a påncil or magic marker to mark the holes where you want to rîute the zip ties. On the center grilles, the cable ties will attañh to the plastic OEM grille slats. An approximate locàtion is shown in the picture below. Note: Some of the phîtos and examples shown are from the Scion install, some are from the S2000 install and some are from the Civic install. The procedures apply to all three models. Page 2 GrilleGuy.com, LLC Ståp 3 Á Route a cable tie through an opening in the grillå (from the back) and then through the front of the grillå via an adjacent hole as shown on the example below